Notifications
Clear all
Justin Porteus
Skupina: Registrovaný
Přidal se: 2019/12/07
Active Member
1
| Amazon link is dead. Found this one: Seems to fit the spec... | před 5 years | |
| And actually, just some further info - I printed the piece i... | před 5 years | |
| Lubricating filament passage for Lack enclosure? | před 5 years | |
|
Shift in colour during print In forum Hardware, firmware and software help |
před 6 years | |
|
I cleaned all the smooth rods and applied some of the grease... In forum Hardware, firmware and software help |
před 6 years | |
|
Ok, I unplugged it and moved the Y axis, and it is definitel... In forum Hardware, firmware and software help |
před 6 years | |
|
Printer making squeaking noises In forum Hardware, firmware and software help |
před 6 years | |
| Ok, I jumped the gun and didn't wait for an answer, I went a... | před 6 years | |
| Just to confirm that I am doing the right thing - I just thr... | před 6 years | |
| Where do I find the gcode for this? Is it custom gcode, or ... | před 6 years | |
| Here are the Z height calibration squares. -0.89 was where ... | před 6 years | |
| First layer Z height | před 6 years |