Notifications
Clear all
juan.s10
Grupa: Zarejestrowany
Dołączył: 2019/03/13
Active Member
1
| I printed the whistle: I think the problem is from the ... | 6 years temu | |
| After repairing the y-axis, I did what you said. I raised th... | 6 years temu | |
| Yes. The drive pulley grub screws were not properly tightene... | 6 years temu | |
| Those loops of free, isolated extrusion and y-layer shifts l... | 6 years temu | |
| I guess it's too bad when top surface is even worse than bot... | 6 years temu | |
| I ran the calibration wizard. the calibration was correct. T... | 6 years temu | |
| I have lowered the PINDA sensor a bit: Now I will run the... | 6 years temu | |
| A good check for first layer is a it should not have a rough... | 6 years temu | |
| Hi. This is the height of the extruder and the PINDA that I ... | 6 years temu | |
| thank you. | 6 years temu | |
| My new prusa i3 MK3 is printing horrific | 6 years temu |