Notifications
Clear all
juan.s10
Skupina: Registrovaný
Přidal se: 2019/03/13
Active Member
1
I printed the whistle: I think the problem is from the ... | před 6 years | |
After repairing the y-axis, I did what you said. I raised th... | před 6 years | |
Yes. The drive pulley grub screws were not properly tightene... | před 6 years | |
Those loops of free, isolated extrusion and y-layer shifts l... | před 6 years | |
I guess it's too bad when top surface is even worse than bot... | před 6 years | |
I ran the calibration wizard. the calibration was correct. T... | před 6 years | |
I have lowered the PINDA sensor a bit: Now I will run the... | před 6 years | |
A good check for first layer is a it should not have a rough... | před 6 years | |
Hi. This is the height of the extruder and the PINDA that I ... | před 6 years | |
thank you. | před 6 years | |
My new prusa i3 MK3 is printing horrific | před 6 years |