Prusa3D Forum

Notifications

Clear all

jslick007

Groupe: Enregistré

A(ont) rejoint: 2017/04/07

Active Member

	You likely only really need a new PEI sheet which is availab... Dans le forum Others (Archive)	il y a 7 years
	Have you tried tuning your extruder multiplier? I've had sim... Dans le forum Others (Archive)	il y a 7 years
	If you change T? to T0 in your startup GCODE, it'll select e... Dans le forum Others (Archive)	il y a 7 years
	I ordered 5 replacement PTFE liners with the correct chamfer... Dans le forum Others (Archive)	il y a 7 years
	I put this in my Start GCODE in Slic3r PE to do exactly that... Dans le forum Improvements (Archive)	il y a 7 years
	I have the MK2S older 2-screw design on my MK2S, and the MMU... Dans le forum Improvements (Archive)	il y a 7 years
	I used the GCODE that Slic3r exported for the unload/load/wi... Dans le forum Others (Archive)	il y a 7 years
	Simplify 3D MMU profile Dans le forum Others (Archive)	il y a 7 years
	I read the post and I'm using the 98A that came with my Mk2S... Dans le forum Others (Archive)	il y a 8 years
	Printing w/Flexfill Dans le forum Others (Archive)	il y a 8 years
	How long are you guys getting before the sock starts to fall... Dans le forum Improvements (Archive)	il y a 8 years
	When it happens for me, it happens only on ABS which I print... Dans le forum Others (Archive)	il y a 8 years
	Following with interest as I recently started experiencing t... Dans le forum Others (Archive)	il y a 8 years
	I recently had this happen on my older Mk2 that has way more... Dans le forum Others (Archive)	il y a 8 years
	The limitations of the Cura implementation in OctoPi has cau... Dans le forum Software (Archive)	il y a 8 years
	Thanks Peter. Based on your message, I'm assuming it's tryin... Dans le forum Others (Archive)	il y a 8 years
	I had this problem, although it didn't stop extruding, it di... Dans le forum Others (Archive)	il y a 8 years
	PINDA Heating Message Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

565 Forums

64.1 K Sujets

448.9 K Messages

19 En-ligne

70.1 K Membres

Le dernier des messages: 3D printed E-100 ( with Maus Turret ) Notre nouveau membre: Heiko910 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé