Čeština
Fóra
Uživatelé
jslick007
Aktivita
 
Notifications
Clear all
jslick007
jslick007
Skupina: Registrovaný
Přidal se: 2017/04/07
Active Member
1
Profile Aktivita
You likely only really need a new PEI sheet which is availab...

In forum Others (Archive)

 před 7 years
Have you tried tuning your extruder multiplier? I've had sim...

In forum Others (Archive)

 před 7 years
If you change T? to T0 in your startup GCODE, it'll select e...

In forum Others (Archive)

 před 7 years
I ordered 5 replacement PTFE liners with the correct chamfer...

In forum Others (Archive)

 před 7 years
I put this in my Start GCODE in Slic3r PE to do exactly that...

In forum Improvements (Archive)

 před 7 years
I have the MK2S older 2-screw design on my MK2S, and the MMU...

In forum Improvements (Archive)

 před 7 years
I used the GCODE that Slic3r exported for the unload/load/wi...

In forum Others (Archive)

 před 7 years
Simplify 3D MMU profile

In forum Others (Archive)

 před 7 years
I read the post and I'm using the 98A that came with my Mk2S...

In forum Others (Archive)

 před 7 years
Printing w/Flexfill

In forum Others (Archive)

 před 7 years
How long are you guys getting before the sock starts to fall...

In forum Improvements (Archive)

 před 7 years
When it happens for me, it happens only on ABS which I print...

In forum Others (Archive)

 před 7 years
Following with interest as I recently started experiencing t...

In forum Others (Archive)

 před 7 years
I recently had this happen on my older Mk2 that has way more...

In forum Others (Archive)

 před 7 years
The limitations of the Cura implementation in OctoPi has cau...

In forum Software (Archive)

 před 7 years
Thanks Peter. Based on your message, I'm assuming it's tryin...

In forum Others (Archive)

 před 7 years
I had this problem, although it didn't stop extruding, it di...

In forum Others (Archive)

 před 7 years
PINDA Heating Message

In forum Others (Archive)

 před 7 years
Share: