Prusa3D Forum

Benachrichtigungen

Alles löschen

jrdpiper

Gruppe: Registriert

Beigetreten: 2024/06/27

Trusted Member

	I finally got the supports to extend up on the outside of th... Im Forum PrusaSlicer	Vor 2 years
	Snuff, I tried adding a tube like you did in addition to the... Im Forum PrusaSlicer	Vor 2 years
	Everything arrived and is installed. For good measure I did ... Im Forum PrusaSlicer	Vor 2 years
	I'm going to stand down for a few days. I noticed that the i... Im Forum PrusaSlicer	Vor 2 years
	thanks, i'll look at the cleaning the bed and recalibrate th... Im Forum PrusaSlicer	Vor 2 years
	Snuffleupagus I ran your file unaltered, and it detached fro... Im Forum PrusaSlicer	Vor 2 years
	thanks for the file. I'll try it in the morning with the spe... Im Forum PrusaSlicer	Vor 2 years
	I saved all the parameters from the project file you sent, a... Im Forum PrusaSlicer	Vor 2 years
	I agree a chamfer would probably print better but aesthetica... Im Forum PrusaSlicer	Vor 2 years
	Snuffleupagus, I did try to run it but it is for the mk3s no... Im Forum PrusaSlicer	Vor 2 years
	Early attempts had no support which gave the same poor print... Im Forum PrusaSlicer	Vor 2 years
	thanks. look at the first picture in the original post which... Im Forum PrusaSlicer	Vor 2 years
	I did another print and left the support material in place. ... Im Forum PrusaSlicer	Vor 2 years
	How can I increase the support contact area when using suppo... Im Forum PrusaSlicer	Vor 2 years
	Thanks for the help with the supports. I added the cylinder... Im Forum PrusaSlicer	Vor 2 years
	Yes I did have trouble getting abs to print. The problem s... Im Forum PrusaSlicer	Vor 2 years
	I'll give some petg or asa a try if I can find it in ivory. ... Im Forum PrusaSlicer	Vor 2 years
	Thanks for the extra effort. PLA is where I started. Unfortu... Im Forum PrusaSlicer	Vor 2 years
	Thanks for the help. Yes I'm using abs. Pla was too brittle.... Im Forum PrusaSlicer	Vor 2 years
	Good memory it is the bottom (sole) and negative battery con... Im Forum PrusaSlicer	Vor 2 years

Seite 1 / 3 Nächstes

Forums-Statistiken

598 Foren

71 K Themen

497.6 K Beiträge

12 Online

82.3 K Mitglieder

Letzter Beitrag: Modified Spool Holder to align filament tube? Unser neuestes Mitglied: Teen Patti Neueste Beiträge Ungelesene Beiträge Schlagwörter

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen