jrdpiper – Activité – Prusa3D Forum

Notifications

Clear all

jrdpiper

Groupe: PreRegistered

A(ont) rejoint: 2024/06/27

Titre: Membre

	I just replied, got an internet error and lost the 1st respo... Dans le forum How do I print this? (Printing help)	il y a 4 years
	The overhang was why I added the supports. As I said previo... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Thanks for the suggestion. I removed the supports and it di... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Attached is the view after it was sliced. What was showing b... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I zipped the .3mf from slicer and attached it. Sole-... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I zipped the .3mf from slicer and attached it. Sole-... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Very poor print quality on underside of ABS even with suppor... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Thanks, I finally heard back from the forum admin. They said... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	How do I reach a forum admin to see if my id is blocked fro... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Not sure what I'm doing wrong. I've attached a zip of the 3m... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	last try didn't save Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Here is the zip of the 3mf file for the abs version. Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Only on one side. It looks like it is 45 deg between the re... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	what is causing this defect in both abs and pla prints on a ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	close this out. Turned out to be a bad caliper. I used anoth... Dans le forum PrusaSlicer	il y a 4 years
	printing at wrong size from Fusion 360 Dans le forum PrusaSlicer	il y a 4 years
	problem on startup MK3S Dans le forum Hardware, firmware and software help	il y a 5 years

Page 3 / 3 Précédent

Statistiques du forum

585 Forums

68.1 K Sujets

477 K Messages

12 En-ligne

75.8 K Membres

Le dernier des messages: Anyone tried USB SD-card reader with high-endurance SD card instead of USB-stick? Notre nouveau membre: Tommy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé