Prusa3D Forum

Notifiche

Cancella tutti

jrdpiper

Gruppo: Registrato

Registrato: 2024/06/27

Trusted Member

	I finally got the supports to extend up on the outside of th... Nel forum PrusaSlicer	2 years fa
	Snuff, I tried adding a tube like you did in addition to the... Nel forum PrusaSlicer	2 years fa
	Everything arrived and is installed. For good measure I did ... Nel forum PrusaSlicer	2 years fa
	I'm going to stand down for a few days. I noticed that the i... Nel forum PrusaSlicer	2 years fa
	thanks, i'll look at the cleaning the bed and recalibrate th... Nel forum PrusaSlicer	2 years fa
	Snuffleupagus I ran your file unaltered, and it detached fro... Nel forum PrusaSlicer	2 years fa
	thanks for the file. I'll try it in the morning with the spe... Nel forum PrusaSlicer	2 years fa
	I saved all the parameters from the project file you sent, a... Nel forum PrusaSlicer	2 years fa
	I agree a chamfer would probably print better but aesthetica... Nel forum PrusaSlicer	2 years fa
	Snuffleupagus, I did try to run it but it is for the mk3s no... Nel forum PrusaSlicer	2 years fa
	Early attempts had no support which gave the same poor print... Nel forum PrusaSlicer	2 years fa
	thanks. look at the first picture in the original post which... Nel forum PrusaSlicer	2 years fa
	I did another print and left the support material in place. ... Nel forum PrusaSlicer	2 years fa
	How can I increase the support contact area when using suppo... Nel forum PrusaSlicer	2 years fa
	Thanks for the help with the supports. I added the cylinder... Nel forum PrusaSlicer	2 years fa
	Yes I did have trouble getting abs to print. The problem s... Nel forum PrusaSlicer	2 years fa
	I'll give some petg or asa a try if I can find it in ivory. ... Nel forum PrusaSlicer	2 years fa
	Thanks for the extra effort. PLA is where I started. Unfortu... Nel forum PrusaSlicer	2 years fa
	Thanks for the help. Yes I'm using abs. Pla was too brittle.... Nel forum PrusaSlicer	2 years fa
	Good memory it is the bottom (sole) and negative battery con... Nel forum PrusaSlicer	2 years fa

Pagina 1 / 3 Avanti

Statistiche Forum

598 Forum

71 K Discussioni

497.6 K Post

14 Online

82.3 K Utenti

Post recenti: Update...(Kind of) Ultimo utente registrato: Teen Patti Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso