Prusa3D Forum

Notifications

Clear all

jrdpiper

Groupe: PreRegistered

A(ont) rejoint: 2024/06/27

Titre: Membre

	I finally got the supports to extend up on the outside of th... Dans le forum PrusaSlicer	il y a 1 year
	Snuff, I tried adding a tube like you did in addition to the... Dans le forum PrusaSlicer	il y a 1 year
	Everything arrived and is installed. For good measure I did ... Dans le forum PrusaSlicer	il y a 1 year
	I'm going to stand down for a few days. I noticed that the i... Dans le forum PrusaSlicer	il y a 1 year
	thanks, i'll look at the cleaning the bed and recalibrate th... Dans le forum PrusaSlicer	il y a 1 year
	Snuffleupagus I ran your file unaltered, and it detached fro... Dans le forum PrusaSlicer	il y a 1 year
	thanks for the file. I'll try it in the morning with the spe... Dans le forum PrusaSlicer	il y a 1 year
	I saved all the parameters from the project file you sent, a... Dans le forum PrusaSlicer	il y a 1 year
	I agree a chamfer would probably print better but aesthetica... Dans le forum PrusaSlicer	il y a 1 year
	Snuffleupagus, I did try to run it but it is for the mk3s no... Dans le forum PrusaSlicer	il y a 1 year
	Early attempts had no support which gave the same poor print... Dans le forum PrusaSlicer	il y a 1 year
	thanks. look at the first picture in the original post which... Dans le forum PrusaSlicer	il y a 1 year
	I did another print and left the support material in place. ... Dans le forum PrusaSlicer	il y a 1 year
	How can I increase the support contact area when using suppo... Dans le forum PrusaSlicer	il y a 1 year
	Thanks for the help with the supports. I added the cylinder... Dans le forum PrusaSlicer	il y a 1 year
	Yes I did have trouble getting abs to print. The problem s... Dans le forum PrusaSlicer	il y a 1 year
	I'll give some petg or asa a try if I can find it in ivory. ... Dans le forum PrusaSlicer	il y a 1 year
	Thanks for the extra effort. PLA is where I started. Unfortu... Dans le forum PrusaSlicer	il y a 1 year
	Thanks for the help. Yes I'm using abs. Pla was too brittle.... Dans le forum PrusaSlicer	il y a 1 year
	Good memory it is the bottom (sole) and negative battery con... Dans le forum PrusaSlicer	il y a 1 year

Page 1 / 3 Suivant

Statistiques du forum

585 Forums

68.1 K Sujets

477 K Messages

9 En-ligne

75.7 K Membres

Le dernier des messages: Has anyone tried Siraya Tech Fibreheart PPA yet? Notre nouveau membre: Tommy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé