Notifications
Clear all
joseph.k
joseph.k
Groupe: Enregistré
A(ont) rejoint: 2016/11/16
Active Member
1
Sorry, both of them are running Windows 10

Dans le forum Others (Archive)

il y a 8 years
MK2 won't connect to a PC anymore.

Dans le forum Others (Archive)

il y a 8 years
So, when I installed it without changing anything else I got...

Dans le forum Improvements (Archive)

il y a 8 years
I replaced my stock extruder motor with a pancake motor. 270...

Dans le forum Improvements (Archive)

il y a 8 years
I actually just had the same thing happen to me. Since the t...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Only one side of each bearing track on those SKF bearings wo...

Dans le forum Improvements (Archive)

il y a 8 years
Having limited ABS experience my guess would be the parts we...

Dans le forum Others (Archive)

il y a 8 years
That isn't an E3D nozzle so I wonder if it is shorter than t...

Dans le forum Others (Archive)

il y a 8 years
I printed the 3 large parts with PETG and the 2 small pieces...

Dans le forum Improvements (Archive)

il y a 8 years
I have been slowly modeling something like this myself. So i...

Dans le forum Improvements (Archive)

il y a 8 years
Just printed, but chain seem to be little rigid 🙁 I expecte...

Dans le forum Improvements (Archive)

il y a 8 years
I have run the machine in it's stock setup which was way too...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
Did you use the astrosyn dampers with igus bearings installe...

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
I have only had my mk2 for about a week. But one thing I did...

Dans le forum Hardware, firmware and software help

il y a 8 years
I have one of the 40mm Noctua fans coming in the mail today....

Dans le forum Prusa i3 kit (Archive)

il y a 8 years
I ordered the orange kit on November 16th. I emailed support...

Dans le forum General discussion, announcements and releases

il y a 8 years
Partager :