Notifications
Clear all
Jon M
Skupina: Registrovaný
Přidal se: 2021/07/06
Active Member
1
| Hotspots (or coldspots) on HeatBed | před 3 years | |
| nope, sounds good. | před 3 years | |
| Finally success after resetting PINDA, calibrated z to -1.3 ... | před 3 years | |
| Top side 49C0F23F-6092-4949-A8DC-DAE3541BB51B.jpeg | před 3 years | |
| Adjusted z to -0.205, looked nice and flat at 12x , then got... | před 3 years | |
| So I cleaned the plate with soap and hot water, adjusted the... | před 3 years | |
| RE: Struggling with first layer, print slipping. Odd Live Z ... | před 3 years | |
| @bogdanh I'm down to -1.90 and still having issues with non-... | před 3 years | |
| Next pass was at 75% speed and hotbed temp of 80 deg C. Thi... | před 3 years | |
| So, after searching the forum, I made 2 changes, 75% speed a... | před 3 years | |
| I had the same thing happen, but in an odd order. Got it to... | před 3 years |