Prusa3D Forum

Notifications

Clear all

Jon

Grupa: Zarejestrowany

Dołączył: 2016/09/30

Active Member

	Setting TMC currents (G-codes) (MK3): Standard M907 G-code c... In forum General discussion, announcements and releases	6 years temu
	For the benifit of future travelers I report that I have tri... In forum Others (Archive)	8 years temu
	Problem solved. Renaming 'Macintosh HD' to 'Macintosh.HD' di... In forum Prusa i3 kit (Archive)	8 years temu
	I put the sock on and it has made all the diference. No issu... In forum Improvements (Archive)	8 years temu
	Thanks Aaron and Peter for your help. My printer is working ... In forum Improvements (Archive)	8 years temu
	Definitely G6, bearing steel with induction hardening. I am ... In forum Hardware, firmware and software help	8 years temu
	I'm not sure myself, but I am willing to bet the jump from t... In forum Hardware, firmware and software help	8 years temu
	What options would be optimal: Material: bearing steel or 44... In forum Hardware, firmware and software help	8 years temu
	Upgrade E3D heater cartridge? In forum Improvements (Archive)	8 years temu
	These alignment sticks are fantastic. Great job. I was cons... In forum Improvements (Archive)	8 years temu
	I used the Misumi bearings in my initial build based on the ... In forum Hardware, firmware and software help	8 years temu

Statystyki Forum

565 Fora

63.6 K Tematy

446 K Posty

22 Online

68.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte