Prusa3D Forum

Notifications

Clear all

Jon

Skupina: Registrovaný

Přidal se: 2016/09/30

Active Member

	Setting TMC currents (G-codes) (MK3): Standard M907 G-code c... In forum General discussion, announcements and releases	před 6 years
	For the benifit of future travelers I report that I have tri... In forum Others (Archive)	před 8 years
	Problem solved. Renaming 'Macintosh HD' to 'Macintosh.HD' di... In forum Prusa i3 kit (Archive)	před 8 years
	I put the sock on and it has made all the diference. No issu... In forum Improvements (Archive)	před 8 years
	Thanks Aaron and Peter for your help. My printer is working ... In forum Improvements (Archive)	před 8 years
	Definitely G6, bearing steel with induction hardening. I am ... In forum Hardware, firmware and software help	před 8 years
	I'm not sure myself, but I am willing to bet the jump from t... In forum Hardware, firmware and software help	před 8 years
	What options would be optimal: Material: bearing steel or 44... In forum Hardware, firmware and software help	před 8 years
	Upgrade E3D heater cartridge? In forum Improvements (Archive)	před 8 years
	These alignment sticks are fantastic. Great job. I was cons... In forum Improvements (Archive)	před 8 years
	I used the Misumi bearings in my initial build based on the ... In forum Hardware, firmware and software help	před 8 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446 K Příspěvky

24 Online

68.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed