Prusa3D Forum

Notifications

Clear all

JohnD

Groupe: Enregistré

A(ont) rejoint: 2019/03/10

Active Member

	Thank you guys so much for the information. You have blown m... Dans le forum How do I print this? (Printing help)	il y a 6 years
	But its doing the same texture on the top of the model? Are ... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Is this under extrusion? Or over? Dans le forum How do I print this? (Printing help)	il y a 6 years
	RE: Weird top layer and above supports... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Weird top layer and above supports... Dans le forum How do I print this? (Printing help)	il y a 6 years
	This was off the stock Prusa SD card that came with my MK3S.... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Thanks! I was referring to the top layers, where the legs an... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Top Layer Issue Dans le forum How do I print this? (Printing help)	il y a 6 years
	Should I just do the wizard again? Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	This can't be right... Dans le forum Assembly and first prints troubleshooting	il y a 6 years

Statistiques du forum

585 Forums

68.1 K Sujets

477.1 K Messages

9 En-ligne

75.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé