Notifications
Clear all
JohnD
Skupina: Registrovaný
Přidal se: 2019/03/10
Active Member
1
|
Thank you guys so much for the information. You have blown m... In forum How do I print this? (Printing help) |
před 6 years | |
|
But its doing the same texture on the top of the model? Are ... In forum How do I print this? (Printing help) |
před 6 years | |
|
Is this under extrusion? Or over? In forum How do I print this? (Printing help) |
před 6 years | |
|
RE: Weird top layer and above supports... In forum How do I print this? (Printing help) |
před 6 years | |
|
Weird top layer and above supports... In forum How do I print this? (Printing help) |
před 6 years | |
|
This was off the stock Prusa SD card that came with my MK3S.... In forum How do I print this? (Printing help) |
před 6 years | |
|
Thanks! I was referring to the top layers, where the legs an... In forum How do I print this? (Printing help) |
před 6 years | |
|
Top Layer Issue In forum How do I print this? (Printing help) |
před 6 years | |
| Should I just do the wizard again? | před 6 years | |
| This can't be right... | před 6 years |