Notifications
Clear all
john.f14
john.f14
Group: Registered
Joined: 2017/08/11
Active Member
1
Well, I did a live chat with support to try to solve this. ...

In forum Assembly and first prints troubleshooting

7 years ago
In this case, all 3 calibrations were done cold at room temp...

In forum Assembly and first prints troubleshooting

7 years ago
So I've reset/rerun the calibration 3 times now without any ...

In forum Assembly and first prints troubleshooting

7 years ago
Seems this could really use some follow up. I'm fighting wi...

In forum Assembly and first prints troubleshooting

7 years ago
Yup, that's reasonable. Apparently a CC is ISO to 0.76mm, s...

In forum Prusa i3 kit (Archive)

7 years ago
Just from comparing with my own, your PINDA looks way too hi...

In forum Prusa i3 kit (Archive)

7 years ago
I'm less than a week into mine, and I sure wouldn't. You're...

In forum Prusa i3 kit (Archive)

7 years ago
Re: the first question and his links, I just asked the same ...

In forum Prusa i3 kit (Archive)

7 years ago
Ha, thanks and sorry! I couldn't think of what people would...

In forum Prusa i3 kit (Archive)

7 years ago
Extruder Dribble

In forum Prusa i3 kit (Archive)

7 years ago
Sorry to bump an old topic, but I'm possibly having the same...

In forum Others (Archive)

7 years ago
Also, looks like I'm not alone: Just couldn't find any ref...

In forum Prusa i3 kit (Archive)

7 years ago
OK - that's good to know. It seems that maybe my issue is t...

In forum Prusa i3 kit (Archive)

7 years ago
Tricky without aiming for anything specific on the bottom. ...

In forum Prusa i3 kit (Archive)

7 years ago
Pretty sure that isn't it, the bearings are on the right sid...

In forum Prusa i3 kit (Archive)

7 years ago
Front Calibration Points Unreachable

In forum Prusa i3 kit (Archive)

7 years ago
Share: