|
Well, I did a live chat with support to try to solve this. ... Nel forum Assembly and first prints troubleshooting |
7 years fa |
|
In this case, all 3 calibrations were done cold at room temp... Nel forum Assembly and first prints troubleshooting |
7 years fa |
|
So I've reset/rerun the calibration 3 times now without any ... Nel forum Assembly and first prints troubleshooting |
7 years fa |
|
Seems this could really use some follow up. I'm fighting wi... Nel forum Assembly and first prints troubleshooting |
7 years fa |
|
Yup, that's reasonable. Apparently a CC is ISO to 0.76mm, s... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Just from comparing with my own, your PINDA looks way too hi... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
I'm less than a week into mine, and I sure wouldn't.
You're... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Re: the first question and his links, I just asked the same ... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Ha, thanks and sorry! I couldn't think of what people would... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Extruder Dribble Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Sorry to bump an old topic, but I'm possibly having the same... Nel forum Others (Archive) |
7 years fa |
|
Also, looks like I'm not alone:
Just couldn't find any ref... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
OK - that's good to know. It seems that maybe my issue is t... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Tricky without aiming for anything specific on the bottom. ... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Pretty sure that isn't it, the bearings are on the right sid... Nel forum Prusa i3 kit (Archive) |
7 years fa |
|
Front Calibration Points Unreachable Nel forum Prusa i3 kit (Archive) |
7 years fa |
