Français
Forums
Membres
JohanN
Activité
 
Notifications
Clear all
JohanN
JohanN
Groupe: Enregistré
A(ont) rejoint: 2021/05/27
Eminent Member
2
Profil Activité
After Firmware update to middle

Dans le forum Hardware, firmware and software help

 il y a 2 years
Thanks

Dans le forum Hardware, firmware and software help

 il y a 3 years
The vid of the problem

Dans le forum Hardware, firmware and software help

 il y a 3 years
I think as I can see where the metal ball is going in is wor...

Dans le forum Hardware, firmware and software help

 il y a 3 years
mid print Peep and asked to pull the fillement and back in

Dans le forum Hardware, firmware and software help

 il y a 3 years
How to fix this corners

Dans le forum How do I print this? (Printing help)

 il y a 4 years
- Linear bearing U-bolt screws not tightened enough checked ...

Dans le forum Hardware, firmware and software help

 il y a 4 years
@cwbullet OEM barrings from Prusa, Printer is 1 week old and...

Dans le forum Hardware, firmware and software help

 il y a 4 years
Resonating bed

Dans le forum Hardware, firmware and software help

 il y a 4 years
Update.. i cleaned it with water and soap a lot of water whe...

Dans le forum Assembly and first prints troubleshooting

 il y a 4 years
@peter-m ill do that this evening. thanks for your reply

Dans le forum Assembly and first prints troubleshooting

 il y a 4 years
I am... i already scratched the surface 🙁

Dans le forum Assembly and first prints troubleshooting

 il y a 4 years
I am... i already scratched the surface 🙁

Dans le forum Assembly and first prints troubleshooting

 il y a 4 years
The part cooling fan at the front is controlled by gcode. Fo...

Dans le forum Assembly and first prints troubleshooting

 il y a 4 years
Also the brim it self is not holding

Dans le forum Assembly and first prints troubleshooting

 il y a 4 years
First layer petg won’t stick anymore

Dans le forum Assembly and first prints troubleshooting

 il y a 4 years
Page 2 / 2
Partager :