Čeština
Fóra
Uživatelé
JohanN
Aktivita
 
Notifications
Clear all
JohanN
JohanN
Skupina: Registrovaný
Přidal se: 2021/05/27
Eminent Member
2
Profile Aktivita
After Firmware update to middle

In forum Hardware, firmware and software help

 před 2 years
Thanks

In forum Hardware, firmware and software help

 před 3 years
The vid of the problem

In forum Hardware, firmware and software help

 před 3 years
I think as I can see where the metal ball is going in is wor...

In forum Hardware, firmware and software help

 před 3 years
mid print Peep and asked to pull the fillement and back in

In forum Hardware, firmware and software help

 před 3 years
How to fix this corners

In forum How do I print this? (Printing help)

 před 4 years
- Linear bearing U-bolt screws not tightened enough checked ...

In forum Hardware, firmware and software help

 před 4 years
@cwbullet OEM barrings from Prusa, Printer is 1 week old and...

In forum Hardware, firmware and software help

 před 4 years
Resonating bed

In forum Hardware, firmware and software help

 před 4 years
Update.. i cleaned it with water and soap a lot of water whe...

In forum Assembly and first prints troubleshooting

 před 4 years
@peter-m ill do that this evening. thanks for your reply

In forum Assembly and first prints troubleshooting

 před 4 years
I am... i already scratched the surface 🙁

In forum Assembly and first prints troubleshooting

 před 4 years
I am... i already scratched the surface 🙁

In forum Assembly and first prints troubleshooting

 před 4 years
The part cooling fan at the front is controlled by gcode. Fo...

In forum Assembly and first prints troubleshooting

 před 4 years
Also the brim it self is not holding

In forum Assembly and first prints troubleshooting

 před 4 years
First layer petg won’t stick anymore

In forum Assembly and first prints troubleshooting

 před 4 years
Stránka 2 / 2
Share: