Notifications
Clear all
Joe Heaton
Skupina: Registrovaný
Přidal se: 2020/07/13
Active Member
1
Okay, Thanks I will try printing at 230c and see if that mak... In forum How do I print this? (Printing help) |
před 3 years | |
Hi Chuck, 3DJake - ecoPLA Matt Orange Thanks Joe In forum How do I print this? (Printing help) |
před 3 years | |
Matt filament print settings In forum How do I print this? (Printing help) |
před 3 years | |
@joantabb Hi Joan, Thanks for the suggestions. I used an all... In forum Hardware, firmware and software help |
před 4 years | |
Need to get jammed filament out of hotend In forum Hardware, firmware and software help |
před 4 years | |
I have replaced the nozzle and am still having the same extr... In forum Hardware, firmware and software help |
před 4 years | |
Thanks for the reply. I have done a number of cold pulls and... In forum Hardware, firmware and software help |
před 4 years | |
Extruder Gear tightness - unable to find the right balance In forum Hardware, firmware and software help |
před 4 years |