Prusa3D Forum

Notifications

Clear all

jlconlin

Groupe: Enregistré

A(ont) rejoint: 2025/01/29

Active Member

	Filament always gets stuck in Nextruder on retraction—but on... Dans le forum Hardware, firmware and software help	il y a 2 weeks
	Great suggestion. I just checked and they all were tight. Dans le forum Hardware, firmware and software help	il y a 3 months
	I don't think it's the pin that has gotten loose. See attach... Dans le forum Hardware, firmware and software help	il y a 3 months
	Thank you! I'll check once it's done printing. I've got it g... Dans le forum Hardware, firmware and software help	il y a 3 months
	1. I'm not sure what pin you are referring to. Is it the one... Dans le forum Hardware, firmware and software help	il y a 3 months
	Filament Feeding Problems with MMU3 Dans le forum Hardware, firmware and software help	il y a 3 months
	Heating self test fails, replaced everything. Still stuck. P... Dans le forum Hardware, firmware and software help	il y a 1 year
	Filament getting jammed pre-loading into MMU—filament tip ke... Dans le forum Assembly and first prints troubleshooting	il y a 1 year

Statistiques du forum

597 Forums

70.7 K Sujets

495.6 K Messages

12 En-ligne

82 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé