Notifications
Clear all
jimD
jimD
Skupina: Registrovaný
Přidal se: 2020/10/02
Trusted Member
3
please post your version of the project. I have something d...

In forum PrusaSlicer

před 6 months
thanks. I tried twice and no complaints but also no file &...

In forum PrusaSlicer

před 6 months
I'm closer but I still don't see support material generated ...

In forum PrusaSlicer

před 6 months
how can I generate support material using object manipulatio...

In forum PrusaSlicer

před 6 months
Is there a way to save object manipulation settings

In forum PrusaSlicer

před 6 months
I found the root cause of my problem. The 3,5 printer was an...

In forum Hardware, firmware and software help

před 7 months
Thanks, lying about the nozzle type got me past the hot end ...

In forum Hardware, firmware and software help

před 7 months
Since I already had some thermal paste, I tried it and the t...

In forum Hardware, firmware and software help

před 8 months
I removed the thermistor and added thermal paste, replaced a...

In forum Hardware, firmware and software help

před 8 months
I just finished converting a working mk3s+ to a 3.5 that can...

In forum Hardware, firmware and software help

před 8 months
I just remembered that I have to zip the project file so I c...

In forum How do I print this? (Printing help)

před 3 years
file didn't append. trying again.

In forum How do I print this? (Printing help)

před 3 years
Because of all of the modifiers that swiss_cheese helped me ...

In forum How do I print this? (Printing help)

před 3 years
How do I get supports in an inside cavity at the bottom of a...

In forum How do I print this? (Printing help)

před 3 years
I've used the .3mf file that you sent to successfully print ...

In forum How do I print this? (Printing help)

před 3 years
I didn't know it existed. I'll have a look. For my applicati...

In forum How do I print this? (Printing help)

před 3 years
Thanks for sharing the details. I think I have enough inform...

In forum How do I print this? (Printing help)

před 3 years
I did read your reply and will go back through it now that I...

In forum How do I print this? (Printing help)

před 3 years
I spent some time today doing side by side comparison betwee...

In forum How do I print this? (Printing help)

před 3 years
I just replied, got an internet error and lost the 1st respo...

In forum How do I print this? (Printing help)

před 3 years
Stránka 2 / 3
Share: