Prusa3D Forum

Notifications

Clear all

jimD

Skupina: Registrovaný

Přidal se: 2020/10/02

Trusted Member

	Snuff, I tried adding a tube like you did in addition to the... In forum PrusaSlicer	před 6 months
	Everything arrived and is installed. For good measure I did ... In forum PrusaSlicer	před 6 months
	I'm going to stand down for a few days. I noticed that the i... In forum PrusaSlicer	před 6 months
	thanks, i'll look at the cleaning the bed and recalibrate th... In forum PrusaSlicer	před 6 months
	Snuffleupagus I ran your file unaltered, and it detached fro... In forum PrusaSlicer	před 6 months
	thanks for the file. I'll try it in the morning with the spe... In forum PrusaSlicer	před 6 months
	I saved all the parameters from the project file you sent, a... In forum PrusaSlicer	před 6 months
	I agree a chamfer would probably print better but aesthetica... In forum PrusaSlicer	před 6 months
	Snuffleupagus, I did try to run it but it is for the mk3s no... In forum PrusaSlicer	před 6 months
	Early attempts had no support which gave the same poor print... In forum PrusaSlicer	před 6 months
	thanks. look at the first picture in the original post which... In forum PrusaSlicer	před 6 months
	I did another print and left the support material in place. ... In forum PrusaSlicer	před 6 months
	How can I increase the support contact area when using suppo... In forum PrusaSlicer	před 6 months
	Thanks for the help with the supports. I added the cylinder... In forum PrusaSlicer	před 7 months
	Yes I did have trouble getting abs to print. The problem s... In forum PrusaSlicer	před 7 months
	I'll give some petg or asa a try if I can find it in ivory. ... In forum PrusaSlicer	před 7 months
	Thanks for the extra effort. PLA is where I started. Unfortu... In forum PrusaSlicer	před 7 months
	Thanks for the help. Yes I'm using abs. Pla was too brittle.... In forum PrusaSlicer	před 7 months
	Good memory it is the bottom (sole) and negative battery con... In forum PrusaSlicer	před 7 months
	Here is what I get. In forum PrusaSlicer	před 7 months

Stránka 1 / 3 Další

Fórum Statistiky

559 Fóra

63.1 K Témata

443.7 K Příspěvky

22 Online

68 K Uživatelé

Poslední Příspěvek: Build build it all in one step with enclosure? Nový Uživatel: etiennep Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed