jhoff80 – Activité – Prusa3D Forum

Notifications

Clear all

jhoff80

Groupe: Enregistré

A(ont) rejoint: 2016/06/19

Trusted Member

	After a while (somewhere between 20 minutes / layer 2 and 45... Dans le forum Others (Archive)	il y a 8 years
	How much higher is safe to increase the retraction settings?... Dans le forum General discussion, announcements and releases	il y a 8 years
	Strangely, the issues I was having seem to have gone away on... Dans le forum Others (Archive)	il y a 8 years
	So as it turns out, as soon as the cooling fan comes on, the... Dans le forum Others (Archive)	il y a 8 years
	Thermal Runaway with 3.0.6? Dans le forum Others (Archive)	il y a 8 years
	Kind of a mess. I've been playing with a head cleaning mech... Dans le forum Others (Archive)	il y a 8 years
	I'm cautiously optimistic about 3.0.6 having fixed my issues... Dans le forum Others (Archive)	il y a 8 years
	Having similar issues here on a prebuilt one. The only way I... Dans le forum Others (Archive)	il y a 8 years
	I've been having a ton of trouble getting the bed level on m... Dans le forum Others (Archive)	il y a 8 years
	Sorry, my mistake. 😳 I had thought that it saved it... Dans le forum Others (Archive)	il y a 8 years
	It seems that whenever I turn my printer off, the position t... Dans le forum Others (Archive)	il y a 8 years

Page 3 / 3 Précédent

Statistiques du forum

565 Forums

63.9 K Sujets

447.7 K Messages

18 En-ligne

69.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé