Prusa3D Forum

Benachrichtigungen

Alles löschen

Jeroen

Gruppe: Registriert

Beigetreten: 2020/11/20

Active Member

	I think i'm confused with the meaning of `Auto generated sup... Im Forum Hardware, firmware and software help	Vor 4 years
	If i tick the box `Generate support material` supports are b... Im Forum Hardware, firmware and software help	Vor 4 years
	Wow... sorry for asking this question. I'll just go ahead an... Im Forum Hardware, firmware and software help	Vor 4 years
	Hi Joan, It's very confusing as the tooltip also says this: ... Im Forum Hardware, firmware and software help	Vor 4 years
	PrusaSlicer 2.2.0 not automatically generating supports Im Forum Hardware, firmware and software help	Vor 4 years
	Tried cleaning it with aceton next to 99% isopropol and wate... Im Forum General discussion, announcements and releases	Vor 4 years
	I'm not really worried as the prints come out ok, just wonde... Im Forum General discussion, announcements and releases	Vor 4 years
	RE: Marks on print bed Im Forum General discussion, announcements and releases	Vor 4 years
	@clemens-m I have the same problem but only when using Prusa... Im Forum General discussion, announcements and releases	Vor 4 years

Forums-Statistiken

559 Foren

62.9 K Themen

442.9 K Beiträge

22 Online

67.7 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen