Prusa3D Forum

Notifications

Clear all

Jeroen

Skupina: Registrovaný

Přidal se: 2020/11/20

Active Member

	I think i'm confused with the meaning of `Auto generated sup... In forum Hardware, firmware and software help	před 4 years
	If i tick the box `Generate support material` supports are b... In forum Hardware, firmware and software help	před 4 years
	Wow... sorry for asking this question. I'll just go ahead an... In forum Hardware, firmware and software help	před 4 years
	Hi Joan, It's very confusing as the tooltip also says this: ... In forum Hardware, firmware and software help	před 4 years
	PrusaSlicer 2.2.0 not automatically generating supports In forum Hardware, firmware and software help	před 4 years
	Tried cleaning it with aceton next to 99% isopropol and wate... In forum General discussion, announcements and releases	před 4 years
	I'm not really worried as the prints come out ok, just wonde... In forum General discussion, announcements and releases	před 4 years
	RE: Marks on print bed In forum General discussion, announcements and releases	před 4 years
	@clemens-m I have the same problem but only when using Prusa... In forum General discussion, announcements and releases	před 4 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.9 K Příspěvky

22 Online

67.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed