Prusa3D Forum

Notifications

Clear all

Jens Chr. I. Thomsen

Groupe: Enregistré

A(ont) rejoint: 2024/04/12

Active Member

	I am pretty sure there were more on my USB drive.Prusa must ... Dans le forum Hardware, firmware and software help	il y a 9 months
	Corrupt USB drive Dans le forum Hardware, firmware and software help	il y a 9 months
	No mine is as on the picture.I just pushed it a little close... Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	I push the pulley in agains the motor and that seems to have... Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	If I make the belt strait with my finger and moves the extru... Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	And the belt is twisted a little bit in the top. Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	Here a some pictures. Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	If I move the extruder by hand I can se the belt moving side... Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	Yes, next time I print.I just cleaned it up. 🙁 Dans le forum Assembly and first prints troubleshooting	il y a 9 months
	Small pieces of the x-belt is laying under the stepper motor Dans le forum Assembly and first prints troubleshooting	il y a 9 months

Statistiques du forum

565 Forums

63.8 K Sujets

447.3 K Messages

21 En-ligne

69.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé