Notifications
Clear all
Jens Chr. I. Thomsen
Skupina: Registrovaný
Přidal se: 2024/04/12
Active Member
1
| WiFi connection failed | před 5 months | |
|
I am pretty sure there were more on my USB drive.Prusa must ... In forum Hardware, firmware and software help |
před 2 years | |
|
Corrupt USB drive In forum Hardware, firmware and software help |
před 2 years | |
| No mine is as on the picture.I just pushed it a little close... | před 2 years | |
| I push the pulley in agains the motor and that seems to have... | před 2 years | |
| If I make the belt strait with my finger and moves the extru... | před 2 years | |
| And the belt is twisted a little bit in the top. | před 2 years | |
| Here a some pictures. | před 2 years | |
| If I move the extruder by hand I can se the belt moving side... | před 2 years | |
| Yes, next time I print.I just cleaned it up. 🙁 | před 2 years | |
| Small pieces of the x-belt is laying under the stepper motor | před 2 years |