Notifications
Clear all
jbroggio
jbroggio
Group: Registered
Joined: 2023/08/23
Eminent Member
2
Will the MMU3 be able to handle PVA supports for PVA prints ...

In forum How do I print this? (Printing help)

2 weeks ago
Suggestion for "why was this print stopped" options

In forum General discussion & User Experience & Ideas

2 weeks ago
(I'm on the 5.1.2 firmware now, for what it's worth)

In forum Input Shaper (MK4)

3 weeks ago
This has recurred (or more accurately, has never really been...

In forum Input Shaper (MK4)

3 weeks ago
Not only do I still have the problem where I can no longer p...

In forum Bugs & Errors

1 month ago
Update: this behavior does not seem to happen if I save the ...

In forum Bugs & Errors

2 months ago
Mk4: files from connect are forever "waiting"

In forum Bugs & Errors

2 months ago
Is there any benefit to a heat block sock in an enclosure?

In forum General discussion, announcements and releases

3 months ago
Thank you very much, I appreciate the advice.

In forum How do I print this? (Printing help)

5 months ago
My MK4 was shipped to Iowa, USA and the total was $847 ($799...

In forum General discussion, announcements and releases

5 months ago
Moving to a .25 nozzle for my Mk4 - what do I need to know? ...

In forum How do I print this? (Printing help)

5 months ago
How can I get better quality on the bottom part of a print, ...

In forum How do I print this? (Printing help)

6 months ago
How can I get the absolute best quality on a Mk4? IS or non ...

In forum How do I print this? (Printing help)

6 months ago
... that is an incredibly good idea. Thank for very much b...

In forum How do I print this? (Printing help)

6 months ago
Well, that leads me to my next question - when you say it us...

In forum General discussion, announcements and releases

6 months ago
Sure. I just mean, like, if I start a print at night before ...

In forum General discussion, announcements and releases

6 months ago
Leaving gluestick residue on the plate - will this hurt PLA ...

In forum How do I print this? (Printing help)

6 months ago
Will it hurt anything if I leave my Mk4 powered on and idle?...

In forum General discussion, announcements and releases

6 months ago
As with before, after about an hour, PrusaConnect was again ...

In forum Input Shaper (MK4)

7 months ago
I found some time. I just booted up my mk4 - Prusa connect c...

In forum Input Shaper (MK4)

7 months ago
Page 1 / 2
Share: