|
Sorry for the late response. Thank you @conrad-2 for the add... In forum Hardware, firmware and software help |
4 weeks ago |
|
Yes, it looked the same as in this post/p> In forum Hardware, firmware and software help |
4 weeks ago |
|
Good to hear it works for you that way. As @conrad wrote...t... In forum Hardware, firmware and software help |
4 weeks ago |
|
Hi there
While your the printer in the video sounds exactl... In forum Hardware, firmware and software help |
4 weeks ago |
|
I have spent some more time on this matter.... I cannot feel... In forum Hardware, firmware and software help |
4 weeks ago |
|
So 35 to 40°C would be okay for the heatbreak temp, but 50° ... In forum Hardware, firmware and software help |
1 month ago |
|
Attempt 7 The print started out quite fine. However, around ... In forum Hardware, firmware and software help |
1 month ago |
|
@diem / @hyiger, just checked the fans and as far as I can s... In forum Hardware, firmware and software help |
1 month ago |
|
I got Prusament Galaxy Black PETG. That is what the above pi... In forum Hardware, firmware and software help |
1 month ago |
|
one more thing I would like to mention is how it looks when ... In forum Hardware, firmware and software help |
1 month ago |
|
When replacing the extruder motor I took the complete nextru... In forum Hardware, firmware and software help |
1 month ago |
|
I have now tried to run some tests and properly document the... In forum Hardware, firmware and software help |
1 month ago |
|
Thank you folks, for your feedback. Very much appreciated. I... In forum Hardware, firmware and software help |
1 month ago |
|
Thanks for your response. What do you mean by the bearings i... In forum Hardware, firmware and software help |
1 month ago |
|
I was too slow editing the last post...here are two pictures... In forum Hardware, firmware and software help |
1 month ago |
|
unable to resolve underextrusion In forum Hardware, firmware and software help |
1 month ago |
