javalabg – Activity – Prusa3D Forum

Notifications

Clear all

javalabg

Group: Registered

Joined: 2019/08/13

Eminent Member

	@tim-m30 Thanks for reply, I'm printing directly from the pa... In forum Hardware, firmware and software help	5 years ago
	PS: I'm sure the sliced gcode is OK, because after reset the... In forum Hardware, firmware and software help	5 years ago
	@tim-m30 Prusa-Slicer 2.1.0+win64 MK3S, FW 3.8.0-2684 In forum Hardware, firmware and software help	5 years ago
	FW 3.8.0 printer stalling after some runs, overrrun buffers? In forum Hardware, firmware and software help	5 years ago
	@ joantabb thank you for your detailed experience, I agree w... In forum Hardware, firmware and software help	5 years ago
	I upgraded to 3.8.0 and did a bunch of calibration series, b... In forum Hardware, firmware and software help	5 years ago
	oh, thank you, that's one of the information I was looking f... In forum Hardware, firmware and software help	5 years ago
	If I do this, I loose the homogenous infill structure at lea... In forum Hardware, firmware and software help	5 years ago
	Understanding Z-value/ problem with the powdered metal sheet In forum Hardware, firmware and software help	5 years ago

Page 2 / 2 Prev

Forum Statistics

566 Forums

63.2 K Topics

444.3 K Posts

21 Online

68.1 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed