Prusa3D Forum

Notifications

Clear all

Jason Damiani

Grupa: Zarejestrowany

Dołączył: 2020/04/12

Active Member

	OK, think I found at least part of the problem. This must ha... In forum Hardware, firmware and software help	5 years temu
	Sorry, I was finishing grad school when I started this threa... In forum Hardware, firmware and software help	5 years temu
	Update: the file printed satisfactorily for a prototype, but... In forum Hardware, firmware and software help	5 years temu
	Reason for gaps in bottom layer/filament sticking to nozzle In forum Hardware, firmware and software help	5 years temu
	New Update: I flashed the printer and ran the set-up wizard.... In forum Hardware, firmware and software help	5 years temu
	Update: So I ran through the set-up wizard again after reset... In forum Hardware, firmware and software help	5 years temu
	i3 MK3S looses xyz calibration after printing In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

565 Fora

63.9 K Tematy

447.6 K Posty

20 Online

69.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte