Prusa3D Forum

Notifications

Clear all

Jason Damiani

Skupina: Registrovaný

Přidal se: 2020/04/12

Active Member

	OK, think I found at least part of the problem. This must ha... In forum Hardware, firmware and software help	před 5 years
	Sorry, I was finishing grad school when I started this threa... In forum Hardware, firmware and software help	před 5 years
	Update: the file printed satisfactorily for a prototype, but... In forum Hardware, firmware and software help	před 5 years
	Reason for gaps in bottom layer/filament sticking to nozzle In forum Hardware, firmware and software help	před 5 years
	New Update: I flashed the printer and ran the set-up wizard.... In forum Hardware, firmware and software help	před 5 years
	Update: So I ran through the set-up wizard again after reset... In forum Hardware, firmware and software help	před 5 years
	i3 MK3S looses xyz calibration after printing In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

565 Fóra

63.9 K Témata

447.6 K Příspěvky

20 Online

69.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed