|
Wanted to post an update in case anyone is interested.
TLDR... In forum Print tips (Archive) |
9 years ago |
|
My experience thus far is that ABS likes to stick to things ... In forum Print tips (Archive) |
9 years ago |
|
I think some of this is going to depend on the ABS you are u... In forum Print tips (Archive) |
9 years ago |
|
Additional pics:
Really bad one...
First p... In forum Print tips (Archive) |
9 years ago |
|
NEEDED: Help with ABS printing. In forum Print tips (Archive) |
9 years ago |
|
I think you will need 0.15 or even 0.10. But of course you c... In forum Prusa i3 kit (Archive) |
9 years ago |
|
I guess you're trying to slice it with layer height too big ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Print Quality: peremiters cut across holes In forum Prusa i3 kit (Archive) |
9 years ago |
|
The "fumes" are not nearly as bad as what people claim. I gu... In forum Print tips (Archive) |
9 years ago |
|
In my case, I have Asthma, and the fumes were enough to make... In forum Print tips (Archive) |
9 years ago |
|
How bad are the fumes from ABS In forum Print tips (Archive) |
9 years ago |
|
As someone who went the kit route here is what I learned and... In forum General discussion, announcements and releases |
9 years ago |
|
Strange pause after into line In forum Prusa i3 kit (Archive) |
9 years ago |
|
I have similar issues when I print (PLA) - even with small i... In forum Print tips (Archive) |
9 years ago |
|
Wanted to post an update to this thread in case anyone comes... In forum Hardware, firmware and software help |
9 years ago |
|
My outsides were slightly higher so used some old motherboar... In forum Hardware, firmware and software help |
10 years ago |
|
UPDATE with Photos.
This post is the back. In forum Hardware, firmware and software help |
10 years ago |
|
UPDATE with Photos.
I took photos from two locations across... In forum Hardware, firmware and software help |
10 years ago |
|
Check squareness with axis, it is a right angled triange acr... In forum Hardware, firmware and software help |
10 years ago |
|
Any thoughts? I am talking about a 100 - 150um difference wh... In forum Hardware, firmware and software help |
10 years ago |
