Benachrichtigungen
Alles löschen
jaschanarveson
jaschanarveson
Gruppe: Registriert
Beigetreten: 2020/01/30
Active Member
1
Update: I just needed to re-tighten the screws holding the h...

Im Forum Hardware, firmware and software help

Vor 7 months
I have a mk4 that has started doing this, too – sometimes un...

Im Forum Hardware, firmware and software help

Vor 7 months
My solution just now, echoing some others on this thread: - ...

Im Forum Hardware, firmware and software help

Vor 9 months
Good idea! I just ordered some short USB-A extenders, too.

Im Forum Assembly and first prints troubleshooting

Vor 10 months
Interestingly, I have a single USB drive that isn't readable...

Im Forum Assembly and first prints troubleshooting

Vor 10 months
This trick (block half the air-flow) totally worked. I'm on...

Im Forum Assembly and first prints troubleshooting

Vor 1 year
Same issue! New mk4, pre-assembled: fan spins fine, but only...

Im Forum Assembly and first prints troubleshooting

Vor 1 year
I just did this successfully. I had a model of a chess-board...

Im Forum PrusaSlicer

Vor 1 year
Curious to see if anyone tries this out...

Im Forum Assembly and first prints troubleshooting

Vor 2 years
How is MK3S+ -> MK4 full different from MK3 -> MK34?

Im Forum Assembly and first prints troubleshooting

Vor 2 years
Hi, all - Thanks for all your suggestions. Working with P...

Im Forum Hardware, firmware and software help

Vor 5 years
@zoltan The display mostly shows strings of random character...

Im Forum Hardware, firmware and software help

Vor 5 years
@karl-herbert Yes – I had the most recent firmware on it, an...

Im Forum Hardware, firmware and software help

Vor 5 years
Update: going back to 3.7.2 didn't work....

Im Forum Hardware, firmware and software help

Vor 5 years
Hi, Robert-rmm200 - Is there a general sense that going back...

Im Forum Hardware, firmware and software help

Vor 5 years
Extra facts: firmware was at 3.8.1, and I went back to 3.8 a...

Im Forum Hardware, firmware and software help

Vor 5 years
i3 mk3 display shows garbage / random characters / gibberish...

Im Forum Hardware, firmware and software help

Vor 5 years
Teilen: