Prusa3D Forum

Notifications

Clear all

Janek

Grupa: Zarejestrowany

Dołączył: 2022/04/07

New Member

	@Artur5, Thanks again. I did the job as needed and it's prin... In forum Hardware, firmware and software help	3 years temu
	Thanks @Artur5 for your help. My very limited knowledge of 3... In forum Hardware, firmware and software help	3 years temu
	@towlerg Thank you for responding. Additional info: 1)The ST... In forum Hardware, firmware and software help	3 years temu
	PrusaSlicer-2.4.1 freezing on some setup In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

566 Fora

63.1 K Tematy

444.1 K Posty

22 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte