Prusa3D Forum

Notifications

Clear all

Janek

Skupina: Registrovaný

Přidal se: 2022/04/07

New Member

	@Artur5, Thanks again. I did the job as needed and it's prin... In forum Hardware, firmware and software help	před 3 years
	Thanks @Artur5 for your help. My very limited knowledge of 3... In forum Hardware, firmware and software help	před 3 years
	@towlerg Thank you for responding. Additional info: 1)The ST... In forum Hardware, firmware and software help	před 3 years
	PrusaSlicer-2.4.1 freezing on some setup In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

566 Fóra

63.1 K Témata

444.1 K Příspěvky

22 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed