Notifications
Clear all
Janek
Groupe: Enregistré
A(ont) rejoint: 2022/04/07
New Member
|
@Artur5, Thanks again. I did the job as needed and it's prin... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Thanks @Artur5 for your help. My very limited knowledge of 3... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
@towlerg Thank you for responding. Additional info: 1)The ST... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
PrusaSlicer-2.4.1 freezing on some setup Dans le forum Hardware, firmware and software help |
il y a 3 years |