Notifications
Clear all
Jane doe
Group: Registered
Joined: 2015/09/11
Active Member
1
|
jack.z thank you.
Installed without drama.
What happened to... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Steps i did: downloaded
Opened firmware updater (on same dr... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Calibrated the bed when it was cold, rookie mistake. In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Tried it, hex file did not flash correctly using the firmwar... In forum Prusa i3 kit (Archive) |
9 years ago | |
|
Extruder working before printing but stops In forum Prusa i3 kit (Archive) |
9 years ago |