Prusa3D Forum

Notifications

Clear all

James Ramsey

Group: Registered

Joined: 2022/06/29

Active Member

	It had been printing fine for a while. This problem seems re... In forum Hardware, firmware and software help	2 years ago
	Crash detected right after start of bed calibration In forum Hardware, firmware and software help	2 years ago
	Now that I've run several prints, it looks like the white li... In forum Hardware, firmware and software help	2 years ago
	FYI, I tried putting white lithium grease on the Bondtech ge... In forum Hardware, firmware and software help	2 years ago
	Yes. It's just the default "QUALITY" settings for a 0.8 mm n... In forum Hardware, firmware and software help	2 years ago
	Creaking noise and blemishes after using new nozzle for a wh... In forum Hardware, firmware and software help	2 years ago

Forum Statistics

565 Forums

63.6 K Topics

446.2 K Posts

19 Online

68.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed