Prusa3D Forum

Notifications

Clear all

jake.l

Groupe: Enregistré

A(ont) rejoint: 2015/07/01

Active Member

	I was running the latest version of Octoprint on Raspberry P... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I tried some of the same gcode files that worked previously ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	printer stuttering Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	KISS vs Slic3r Dans le forum Print tips (Archive)	il y a 9 years
	I rebuilt the base of the machine, making sure it was a perf... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Didn't install the fan mount correctly. Nevermind. Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I removed the bed from the carrier, placed it on the table, ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Still having a lot of problems with this. I ziptied the wobb... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Did you calibrate the printer while everything is preheated ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I also had problems with a corner getting unseated. I used ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	bed leveling wobble during calibration Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	hotend never reaches 285 Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I've also noticed that using the LCD controls with Octoprint... Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Statistiques du forum

559 Forums

63 K Sujets

443.2 K Messages

21 En-ligne

67.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé