Prusa3D Forum

Notifications

Clear all

jake.l

Skupina: Registrovaný

Přidal se: 2015/07/01

Active Member

	I was running the latest version of Octoprint on Raspberry P... In forum Prusa i3 kit (Archive)	před 10 years
	I tried some of the same gcode files that worked previously ... In forum Prusa i3 kit (Archive)	před 10 years
	printer stuttering In forum Prusa i3 kit (Archive)	před 10 years
	KISS vs Slic3r In forum Print tips (Archive)	před 10 years
	I rebuilt the base of the machine, making sure it was a perf... In forum Prusa i3 kit (Archive)	před 10 years
	Didn't install the fan mount correctly. Nevermind. In forum Prusa i3 kit (Archive)	před 10 years
	I removed the bed from the carrier, placed it on the table, ... In forum Prusa i3 kit (Archive)	před 10 years
	Still having a lot of problems with this. I ziptied the wobb... In forum Prusa i3 kit (Archive)	před 10 years
	Did you calibrate the printer while everything is preheated ... In forum Prusa i3 kit (Archive)	před 10 years
	I also had problems with a corner getting unseated. I used ... In forum Prusa i3 kit (Archive)	před 10 years
	bed leveling wobble during calibration In forum Prusa i3 kit (Archive)	před 10 years
	hotend never reaches 285 In forum Prusa i3 kit (Archive)	před 10 years
	I've also noticed that using the LCD controls with Octoprint... In forum Prusa i3 kit (Archive)	před 10 years

Fórum Statistiky

585 Fóra

68 K Témata

476.5 K Příspěvky

11 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed