Avisos
Vaciar todo
Jake Freese
Grupo: PreRegistered
Registrado: 2023/08/18
Título: Miembro
|
I was able to reprint the part with the door open on the enc... En el foro PrusaSlicer |
hace 1 year | |
|
I'm going to have to check this tomorrow as like this evenin... En el foro PrusaSlicer |
hace 1 year | |
|
I will try to roll back to 3.12 tomorrow night. Thank you! En el foro Hardware, firmware and software help |
hace 2 years | |
|
Failure to load with MMU2S to MK3S+ after firmware update En el foro Hardware, firmware and software help |
hace 2 years |