Benachrichtigungen
Alles löschen
J.J. Kucharczyk
J.J. Kucharczyk
Gruppe: Registriert
Beigetreten: 2024/01/29
Eminent Member
2
Thanks. Both plates are cleaned. I guarantee that they are ...

Im Forum Assembly and first prints troubleshooting

Vor 4 months
This works for me... But, now on the back U axis i have nois...

Im Forum Hardware, firmware and software help

Vor 4 months
back side of first layer problem....

Im Forum Assembly and first prints troubleshooting

Vor 4 months
Thank you. I'll try this 🙂

Im Forum How do I print this? (Printing help)

Vor 4 months
The filament was opened yesterday, so there's no chance of m...

Im Forum How do I print this? (Printing help)

Vor 4 months
Thanks. I am printing on GEMBIRD is cheaper here in Denmark ...

Im Forum How do I print this? (Printing help)

Vor 4 months
SUNLU is it s**t brand?

Im Forum How do I print this? (Printing help)

Vor 4 months
PRUSA has taken a step forward with an interesting design, b...

Im Forum General discussion, announcements and releases

Vor 4 months
So now I'm sure that downgrade was not necessary for me. 0.1...

Im Forum Hardware, firmware and software help

Vor 1 year
Thanks, I'm working on it with Prusa Support 🙂 Waiting for ...

Im Forum General discussion, announcements and releases

Vor 2 years
Visible differences in print at different heights.

Im Forum General discussion, announcements and releases

Vor 2 years
Thank you for your reply. In this case, however, all 3 PLA f...

Im Forum General discussion, announcements and releases

Vor 2 years
Filament on the workplate after automat calibrating Z axis.

Im Forum General discussion, announcements and releases

Vor 2 years
Seite 2 / 2
Teilen: