Notifiche
Cancella tutti
Infoteq
Gruppo: Registrato
Registrato: 2024/04/29
Active Member
1
|
Unexpected Seam Nel forum PrusaSlicer |
4 weeks fa | |
|
Well, that was easy. I hadn't even noticed that little error... Nel forum PrusaSlicer |
7 months fa | |
|
Slicing Issue - Phantom Layers Nel forum PrusaSlicer |
7 months fa | |
| You were correct. I restored the default value for the spaci... | 7 months fa | |
| I apologize for the confusion. It's not about belief, but si... | 7 months fa | |
| If what you said was completely accurate, then we'd be able ... | 7 months fa | |
| The part is a test piece that resembles the piece I'm trying... | 7 months fa | |
| Supported Surface Texture Issue | 7 months fa |