Notifications
Clear all
Infoteq
Skupina: Registrovaný
Přidal se: 2024/04/29
Active Member
1
| Thanks for the tip on the seem position indicator. I rarely ... | před 12 months | |
| Unseemly | před 12 months | |
|
Unexpected Seam In forum PrusaSlicer |
před 1 year | |
|
Well, that was easy. I hadn't even noticed that little error... In forum PrusaSlicer |
před 2 years | |
|
Slicing Issue - Phantom Layers In forum PrusaSlicer |
před 2 years | |
| You were correct. I restored the default value for the spaci... | před 2 years | |
| I apologize for the confusion. It's not about belief, but si... | před 2 years | |
| If what you said was completely accurate, then we'd be able ... | před 2 years | |
| The part is a test piece that resembles the piece I'm trying... | před 2 years | |
| Supported Surface Texture Issue | před 2 years |