Notifications
Clear all
Infoteq
Group: Registered
Joined: 2024/04/29
Active Member
1
| Thanks for the tip on the seem position indicator. I rarely ... | 10 months ago | |
| Unseemly | 10 months ago | |
|
Unexpected Seam In forum PrusaSlicer |
1 year ago | |
|
Well, that was easy. I hadn't even noticed that little error... In forum PrusaSlicer |
1 year ago | |
|
Slicing Issue - Phantom Layers In forum PrusaSlicer |
1 year ago | |
| You were correct. I restored the default value for the spaci... | 1 year ago | |
| I apologize for the confusion. It's not about belief, but si... | 1 year ago | |
| If what you said was completely accurate, then we'd be able ... | 1 year ago | |
| The part is a test piece that resembles the piece I'm trying... | 1 year ago | |
| Supported Surface Texture Issue | 1 year ago |