Prusa3D Forum

Notifications

Clear all

IlikeitMalted

Grupa: Zarejestrowany

Dołączył: 2021/08/22

Active Member

	Yes and no. If you turn off the MMU3 via the printer, than t... In forum How do I print this? (Printing help)	1 year temu
	Check your SD-card. On a Windows computer look in explorer f... In forum General discussion, announcements and releases	3 years temu
	I was careful and will just re-check every now and then. I j... In forum Hardware, firmware and software help	3 years temu
	I loosened the tension screws so they were level with the pr... In forum Hardware, firmware and software help	3 years temu
	I think, they are ok. Just half a mm below the printed part.... In forum Hardware, firmware and software help	3 years temu
	Still need to learn, how this forum software works. Second t... In forum Hardware, firmware and software help	3 years temu
	Idler positioning not correctly In forum Hardware, firmware and software help	3 years temu

Statystyki Forum

559 Fora

62.8 K Tematy

442.4 K Posty

23 Online

67.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte