Prusa3D Forum

Notifications

Clear all

IlikeitMalted

Skupina: Registrovaný

Přidal se: 2021/08/22

Active Member

	Yes and no. If you turn off the MMU3 via the printer, than t... In forum How do I print this? (Printing help)	před 1 year
	Check your SD-card. On a Windows computer look in explorer f... In forum General discussion, announcements and releases	před 3 years
	I was careful and will just re-check every now and then. I j... In forum Hardware, firmware and software help	před 3 years
	I loosened the tension screws so they were level with the pr... In forum Hardware, firmware and software help	před 3 years
	I think, they are ok. Just half a mm below the printed part.... In forum Hardware, firmware and software help	před 3 years
	Still need to learn, how this forum software works. Second t... In forum Hardware, firmware and software help	před 3 years
	Idler positioning not correctly In forum Hardware, firmware and software help	před 3 years

Fórum Statistiky

559 Fóra

62.8 K Témata

442.4 K Příspěvky

22 Online

67.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed