Prusa3D Forum

Notifications

Clear all

IBICO74

Groupe: Enregistré

A(ont) rejoint: 2018/08/09

Active Member

	I figured out what was wrong. The pin for the idler wheel h... Dans le forum Hardware, firmware and software help	il y a 6 years
	I get the same error. 17:24:04.034: Unknown G code: $91 G21... Dans le forum How do I print this? (Printing help)	il y a 6 years
	Anyone know where I could put the profiles in the Linux vers... Dans le forum General discussion, announcements and releases	il y a 6 years
	XYZ calibration fail, but print normal Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	I got the same issue with my sensor.. No reaction and under ... Dans le forum Hardware, firmware and software help	il y a 6 years
	The preset that came with my drivers was causing lots of war... Dans le forum Print tips (Archive)	il y a 6 years
	I got the same problem. Recently all long print fail after p... Dans le forum Hardware, firmware and software help	il y a 6 years
	I got a perfect K value by printing a cube 400% and then dro... Dans le forum General discussion, announcements and releases	il y a 6 years
	K value calibration in menu Dans le forum General discussion, announcements and releases	il y a 6 years
	I struggled for days before finding out that there is a cust... Dans le forum General discussion, announcements and releases	il y a 6 years
	My prusa does strange things Dans le forum General discussion, announcements and releases	il y a 6 years

Statistiques du forum

565 Forums

63.9 K Sujets

447.7 K Messages

22 En-ligne

69.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé